Can you explain me the meaning of these choose and when I've to use it? After few seconds the device make a reset and wake up again. If I change from the 1001 to 1002 the display that is under modify (tachometer, rlink, etc) is switching off and I can't use the ddt4all anymore. On the top of the software interface, when you click on the Einstein icon, there is a line where you can select: I've seen that I've to reverse 2 pins in the way to better comunicate with the ecu, right? I've also to remove a resistor (120ohm) from the standard pcb? Can you explain me better when I've to switch from low/high signal and for what kind of ecus? First of all I want to say you thanks a lot for this fantastic software, it's very useful and complete! I use your software with a wifi obd with the PIC18F25K80 on my Megane IV (1.6 dci Bose) and works quite well.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |